Hi,
I try to setup wake on LAN on D2500CC board, but without any success.
After switching off the computer the Link/Activity and Link Speed LEDs switch off, next the Link/Activity LED switch on and after one, two seconds switch off.
At a time when Link/Activity LED is on I can wake up the computer sending to it the wake up package.
I tested PS/2 wake up too. It also work for only a few seconds after the computer is turned off.
Also the RTC alarm event not wake up the computer.
I checked a voltage on +5Vstby power supply pin and it is correct.
The +5V Standby Power Indicator LED is always on.
I tested two D2500CC boards and two different ATX power supplies. I updated the BIOS to the latest version.
Both boards are from the 2013.
Best regards,
Andrzej.